Upgrade your Dodge Challenger’s look with the aggressive Vicrez Rear Spoiler Hellcat Redeye (VZ102182). This step-by-step guide will walk you through the entire installation process, including camera relocation, 3M tape application, and securing the spoiler for a perfect fit.
Tools & Materials Needed
Before starting, gather:
- Vicrez Hellcat Redeye Spoiler (VZ102182) – Available at Vicrez.com
- Clip remover tool
- 10mm wrench & T15 Torx bit
- Pry tool & microfiber cloth
- Razor blade (for 3M tape removal)
- Drill & large drill bit (for camera cable routing)
- Cleaning solution & 3M automotive tape
Step 1: Removing the Factory Spoiler
- Open the trunk and locate the 8 clips holding the trunk liner.
- Use a clip remover to carefully detach them.
- Disconnect the rear camera wire by pressing the clip (a 10mm wrench may help).
- Remove the caps covering the spoiler bolts on each side.
💡 Pro Tip: Cover your paint with a microfiber cloth when prying to avoid scratches.
Step 2: Detaching the Spoiler from 3M Tape
- Use a pry tool to gently lift the spoiler.
- Cut through the 3M tape with a razor blade (3 strips total—two on the sides, one in the rear).
- Apply upward pressure until the spoiler releases.
⚠️ Caution: Be careful not to damage the camera wire!
Step 3: Transferring the Camera to the New Spoiler
- Remove the OEM camera using a T15 Torx bit.
- Detach the cable by lifting the clip with a small screwdriver.
- Mount the camera onto the Vicrez spoiler’s bracket using the provided hardware.
- Drill a hole in the spoiler for the camera cable, then feed it through.
Step 4: Installing the Vicrez Hellcat Spoiler
- Clean the trunk surface thoroughly before applying new 3M tape.
- Align the spoiler, ensuring the screw holes and camera cable fit properly.
- Press firmly to secure the adhesive, then fasten with the included screws.
- Reconnect the camera wire and reattach the trunk liner.
✅ For extra security, use the additional screws provided.
Ready to Order
Final Look & Tips
Once installed, your Challenger will have an aggressive, high-performance stance just like the Hellcat Redeye!
📌 Installation Time: ~30-45 minutes (depending on experience).
Ready to Upgrade?
The Vicrez Rear Spoiler Hellcat Redeye Style (VZ102182) is a must-have for any Challenger owner looking for a factory-style, race-ready appearance.
